Preonic Hi-Pro Wooden Milled Bottom

IMG_7595.JPG
IMG_7591.JPG
IMG_7592.JPG
IMG_7593.JPG
IMG_7594.JPG
IMG_7595.JPG
IMG_7591.JPG
IMG_7592.JPG
IMG_7593.JPG
IMG_7594.JPG

Preonic Hi-Pro Wooden Milled Bottom

85.00

These cases are made-to-order, and will ship three weeks after ordering

Milled locally in Indiana and finished with a danish oil, these high profile cases have 8 holes for attaching to the PCB, and one for the reset button. The edge of the case comes right up to the edge of most standard keycaps. The sidewalls are 4mm thick (rear is 7mm), and the bottom is 3mm thick.

These cases are only compatible with Hi-Pro top plates (available soon) - the plate is optional in these builds, but is recommended for switches without PCB nibs (Matias, some MX switches).

These plates are only compatible with Preonic Rev 2 or later PCBs - earlier PCBs can be made compatible by drilling the 2mm holes to make them 2.85mm - 3.25mm in size.

Main pictures are of special run of Katalox sapwood (unavailable currently).

Comes with:

  • 8 2.5mm plastic inserts that clip into the PCB (link)
  • 8 1/4" 2-56 Stainless Steel Screws (link)
  • 4 rubber feet
Material:
Quantity:
Add To Cart

Pictures below are of Planck cases, and are listed here for spieces reference only.